grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board. Engineer in Wonderland cnc-related blogs are indexed here It is the ...

It’s fair to say that building electronic gadgets is easier now than it ever has been in the past. With low-cost modular components, there’s often just a couple dozen lines of code and a few jumper ...

Over on hackaday.io and deep in the Hackaday Prize, a lot of cool people are playing around with the possibilities of putting coils in printed circuit boards. On the face of it, it makes sense: ...

This book is about DC electric motors and their use in Arduino and Raspberry Pi Zero W based projects. The book includes many tested and working projects where each project has the following ...

ClearCore CLCR-4-13 is an industrial IO and motion controller that can be programmed using the Arduino IDE. It handles up to four axes of step-and-direction motion control (500kHz max step rate), and ...

A new open source robotic arm has this week launched over on Kickstarter called the Dobot, providing an Arduino powered high quality 4-axis parallel-mechanism robot arm. Dobot has been created by a ...